Moog CamEvator SERIES Spécifications télécharger pdf (Page 14)

Part 2: Installation

Figure 7

CAUTION: Pull all slack in the wiring as

you lift the pole into position

to keep from pinching and

possible damage.

5. Ensure that the pole is vertical on all sides. Use a bubble level or

plumb bob to check.

5. Slowly lift the pole into the upright position, aligning the holes of

the Base Plate with the Bolts in the concrete pad (Figure 7).

Part 2: Installation

Figure 8

6. Secure the pole to the pad with fasteners (Figure 8).

Nut

Lock Washer

Flat Washer

Anchor Jig Assembly

Anchor Jig Kit Parts List

Single Straps (4)

Cross Strap (1)

3/4" - 10 Bolts (4)

3/4" Flat Washers (4)

3/4" - 10 Hex Nut (20)

Lock

Washers (4)

Jig Assembly

1 "

6"*

Figure 1

1 1/2"

1. Thread two (2) nuts onto each of the (4) bolts (Figure 1). The end

with 6" of clearance will be the top of the Anchor Jig, the end with

1 1/2" clearance will be the bottom.

NOTE: Because of surface conditions it may be necessary to use

leveling nuts. See step 5 below for information.

8 9

10 11

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21

Pas de commentaire

Moog CamEvator SERIES Spécifications Page 14